Fresh Aero offers a wide assortment of tire air chucks to meet all your tire inflating needs. We have angle chucks in locking and non-locking configuations that fit nicely between valve stems and fairings. We can also supply sraight chucks in an assortment of lengths for aircraft with air stem access holes in the their fairings. All our air chucks are supplied with standard automotive style quick-disconnect fittings. 

Note: All the following lengths are measured from the tip of the chuck to the tip of the quick-disconnect. Also note that the price of some chucks will vary from the standard $6.50 price, depending on the style.

Chuck # 1 .....

This is a combination 7 1/2 inch (191mm) long straight & 30 degree angled chuck. Note: The access hole for the tire stem must be at least 1 1/4 inches (31mm) in diameter to use this chuck.

Chuck # 2 .....

This is the standard two-way angled chuck. The chuck is 7 1/4 inches (185mm) long and the angles are 30 & 60 degrees.

Chuck # 3 .....

This is our extended 6 3/4 inch (172mm) straight chuck. This chuck is similar to our standard straight chuck except for its longer length. It is very useful for those hard to reach tire stems with small access holes in fairings.

Chuck # 4 .....

This is our standard 4 1/4 inch (108mm) long straight chuck. Due to the very narrow tip, this chuck only needs a 9/16 inch (14mm) access hole to pass though.

Chuck # 5 .....

This is our 30 degree, 4 1/8 inches (114mm) long angled locking chuck. The lever is used to lock the chuck onto the tire stem. This chuck is really handy for filling those tires covered with wheel fairings.